(Inside assembly required - Approx 3 hours). For use where entrance doors and hallways are not wide enough to move assembled Speed-Lift inside except in two compact pieces under 60” wide.

EB48  

For use on SL-5000 and SL-6000 models when bumper posts are used in front of lift.

EB68   Drawing

For use on inside SL5000/5001 and SL-6000/6001 lifts to extend through truck height wall doors/bumpers /weather seals and into trucks positioned outside.

EB52

For use on SL-8000 and larger lifts when used with bumper posts positioned in front of the lift.

EB72  Drawing

For use on SL-8000/8001 and larger lifts positioned inside, to extend through wall doors/bumpers/weather seals and into trucks positioned outside.

Available at extra cost for all models

Used for locations where the speed lift is positioned 6” or more above the truck approach grade (please specify difference between truck approach and grade level of Speed-Lift)

Ideal for inside locations where truck heights begin at only 5” or more above Speed-Lift installation floor level (max. lifting height 21”).

Used where insufficient space exists to come off the end of the Speed-Lift platform. (Indicate L or R by facing the truck approach while on the SOP lift platform.

Designed for space saving use with a portion of the lift on a low dock and the remainder in front of the dock, where neither the truck approach nor the low dock surface is sufficiently large enough for the entire Speed-Lift length.

For use where front of four corner leveling is needed.